Here share a easy guide on Ford Diesel Particulate Filer(short call DPF) Regeneration.Below detail the step-by-step procedures,please check and hope you can get useful information from this article.

 

What device you need to do DPF Generation?

Here we take X431 Pro as example,you can choose other devices.

 

Ford DPF Generation detail procedures:

 

Connect X431 Pro Bluetooth DBSCar connector to your car via OBD2 socket.

Open the X431 Software to select “American”–>”Ford”

Select “Ford series software V46.20”

Select”Automatically Search”

Please check the vehicle specification,select”OK”

Select “Fuel Type=Diesel”

Select “System Selection”

Select “PCM (Powertrain Control Module)”.Then Select “OK”

Select “Special Function”–>Select”PCM Service Function”–>Select “OK”

Select “Diesel Particulate Filter Static Regeneration”

Pay attention to the prompt

Turn ignition to the ON Position.And wait system to Reading Fault Codes

Turn ignition to the OFF position.And pay attention to the prompt and click “yes”

Turn ignition to the ON position

Start the engine,the system will be inspecting the temperature of Engine Coolant

The temperature of Engine Coolant must beyond 65 Degree.Then select”OK”

The Test will cost about 2500s,select”Yes”Wait for 2500s,when it complete click OK and Turn ignition to the OFF Position.

The procedure has been performed. Done!

Here is Ford Diesel Particulate Filter Static Regeneration Video Guide.

 

Article from:Launch X431 Perform DPF Static Regeneration for Ford Fiesta 2011