
This is a diy post focus on how to modify Europe version turn signals and install in on USA Ford Focus.
Procedures:
the hole on the back of the euro one is much bigger then the us one
so being that they are about the same size around ,not the hole but the outside..i used a Dremel to cut the top of the us turn sig off ,just i little below the top
once i got the “disk” off i sanded it smooth and made it look nice
after it was sanded i cleaned off the dust and spay painted them black
once they were dry but still a little tacky stuck the “disk” to the back of the euro turn sig
once i had them where i wanted, i used plastic welding to tack it then weld
them (melt them) all the way around
once i had it welded on good i sanded down the welds a little to make it look a little better..then you can paint the backs of them if you want so it looks better..
so now i have euro turn sigs to fit into my wrc bumper,that will fit
my us spec. lights and not have to spend the extra $$$
IF YOU DONT KNOW ABOUT PLASTIC WELDING
all you realy need is a soldering gun or iron
Complete!